
Holy crap, I didn’t realize there was was some Velcro there!! I even looked for it.

Holy crap, I didn’t realize there was was some Velcro there!! I even looked for it.

I just want to say the ergonomic addon pack only the controller straps are any good. A bit confusing to put on but makes more sense when you figure it out.
However the top head strap is complete garbage. Out of all the top straps I’ve seen this one has got to be the worst. Not adjustable at all. I have a big head, regular hats don’t fit me… The headstrap is way too shallow and feels like it’s gonna roll off my head.
Took about a week to get my order email. Then a couple more days to get shipped. Shipping itself only took a couple days.
You can just start the path with a quote and it will auto complete with spaces. I spend a lot of time correcting files with spaces replaced now. The spaces are better. I think music is the most annoying, since I like to use tools like EasyTag to extract metadata from filenames.
So please stop.naming_files.like_this.its_stupid

Clearly post does not understand kernel booting. Initrd will never go away, you need a way to tell the kernel to start systemd, which is usually part of initramfs. Both can be compiled as part of the kernel image which can be directly booted from EFI. So basically EFI->Kernel->Decompress InitramFS->Run Initrd Boot Script (usually ends by kicking off SystemD). Initramfs is compressed to reduce boot partition usage, load faster into ram (more noticeable on HDD). You want the bare minimum of kernel modules available in initramfs to load storage drivers, filesystem, LVM, LUKS. Everything else should be modules on the root filesystem, unless it needed for boot. You can compile these static into the kernel too. Generally modules are preferable as they can be unloaded/reloaded if there is an issue. Also updating initramfs modules is annoying. I wrote my own initrd scripts and custom initramfs. You can build it all with bash scripts and configure the kernel to include the payload.

It’s perfectly fine to host jellyfin online. Use a proxy server to enable TLS and do not use default ports 80/443. Use letsencrypt for free certificates. No need for VPN to access here either. Do not expose any other ports such as SSH on default ports. Lock down your jellyfin server and any other related services behind a VPN service and block access to Internet through other interfaces (except for port forwards on your ISP for jelly). Go high on port ranges since they typically aren’t scanned or blocked. Go dual stack for best results and don’t use your router address for IPv6 more than likely you have your own /64 choose a different address for port forwards. Do not assign this address to your internal servers. Use a reserved unrouted IPv6 range internally and do NAT6. Do not allow any raw IPv6 internet access
Finally!! Can they even catch up at this point? Linux mod managers are insanely good these days. Vortex runs like crap under proton.
One of the few benefits of AI is that modding is so much more accessible these days. I see mod updates almost weekly, sometimes even daily.
Vortex needs to embrace open source or its never going to get the traction it needs.